Said, > it cannot directly read-in RS-232 output from the 53132A > (such as I posted > yesterday). This is because of the Comma the HP unit inserts > in the numbers.
please send short file and I will look what I can do. > Also, Plotter always comes up in scientific notation on the > vertical scale, > I always have to set it to #.6 mode manually. Any chance to > make it come up in > normal notation? This is more severe. Not that it were a problem to change the default scale to whatever. But: The scientic notation FITS ALL while #.6 fits only YOU. Perhaps I think about a way to store such things in the ini-file. Best regards Ulrich > -----Ursprüngliche Nachricht----- > Von: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] Im Auftrag von [EMAIL PROTECTED] > Gesendet: Mittwoch, 30. Mai 2007 22:43 > An: [email protected] > Betreff: Re: [time-nuts] FW: Pendulums & Atomic Clocks & Gravity > > > > In a message dated 5/30/2007 13:06:23 Pacific Daylight Time, > [EMAIL PROTECTED] writes: > > Regards > Ulrich Bangert > > > > Hi Ulrich, > > I am still using plotter daily, easier to use than Stable32. > > Some comments on Plotter: > > it cannot directly read-in RS-232 output from the 53132A > (such as I posted > yesterday). This is because of the Comma the HP unit inserts > in the numbers. > > Any chance you can make Plotter "comma" compatible? > > > Also, Plotter always comes up in scientific notation on the > vertical scale, > I always have to set it to #.6 mode manually. Any chance to > make it come up in > normal notation? > > thanks, > Said > > > > ************************************** See what's free at http://www.aol.com. _______________________________________________ time-nuts mailing list [email protected] https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts _______________________________________________ time-nuts mailing list [email protected] https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
