Nigel, I have some CDs in the store room, which Datum produced which have all their driver software on. I know they are in there somewhere, but since moving the last time (domestic split!), I haven't had a chance to sort through a lot of this stuff.
Will try to take a look over the next couple of days, and if they are still there, then I'll send it over. Rob -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: 06 May 2008 00:35 To: [email protected] Subject: [time-nuts] Datum/Symmetricom BC637PCI Time and Frequency Processor Hi All I've just bought a Datum BC637PCI Time and Frequency Processor on a PCI card from the usual place, model BC635PCI is identical but without the onboard GPS receiver, and am looking for any Windows drivers and/or the basic control software. I've found the manual and other documentation online, also documentation for the very similar Symmetricom BC637PCI_U that replaced it, but cannot find the drivers or software for either. The original Datum config and demo program was BC635CPP.exe, and TRAYTIMECPP.exe was a system clock utility. Symmetricom continued to supply Bc635cpp.exe with the BC637PCI_U but the clock utility was now named TrayTime.exe and there was also some GPS demo software called bc637PCI GPS Demo. I have 7 days after receipt to determine if all is working ok so if anyone can help, particularly with a copy of BC635CPP.exe, I'd be very grateful. regards Nigel GM8PZR _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
