The 5340 Manual is on the Agilent site. Don't know if that will help, but it may have the schematic showing the connections to the TCXO.
73, Dick, W1KSZ -----Original Message----- >From: arie schellaars <[email protected]> >Sent: Mar 11, 2009 10:21 PM >To: Discussion of precise time and frequency measurement <[email protected]> >Cc: [email protected] >Subject: Re: [time-nuts] FTS 1200 9110 1000A-100 1000B pinouts here! > >Hi Time Keepers >Not quite an answer to the below question , but my own request for TCXO >pinout info >on my recent purchase on Ebay. >The TCXO unit was designated to go into a HP5340A unit but the circuit doesn't >seem to match with my oscillator module. >The unit either gets warm or oscillates but NOT both together at the same time. >Can't get a 10 MHz signal out but know it's oscillating by listening to it >with a receiver. >Perhaps it's needs surgery as per recent discussions in this forum. >Or even may need special dual power supply , again as per recent forum >discussions here. >The module was made by Bulova and has p/n of 0960-0153. >It has a 15 way edge connector and a HP P/N of 05340-60036 on the module >"mother" >board. >Other info on the module states it needs +10 and +5vdc > Hope some of you blokes can assist. >Cheers from down under. >Arie Schellaars >VK3DBF > >--- On Sun, 1/3/09, Corby Dawson <[email protected]> wrote: > > >From: Corby Dawson <[email protected]> >Subject: [time-nuts] FTS 1200 9110 1000A-100 1000B pinouts here! >To: [email protected] >Received: Sunday, 1 March, 2009, 1:02 AM > > >Well after re-researcing the pinouts again I decided to post this while >they are fresh. >These Pinouts are for units removed from FTS Cesium standards and were >verified by measurement in the standard. > >PIN 1000B 1000A-100 1200 > 9110 > >1 EFC ground EFC ground EFC ground >EFC ground > >2 EFC +- 10V EFC +- 10V EFC 0 to +10V >EFC 0 to +10V > >3 coarse tune wiper NC NC > NC > >4 +12 pot ref. (10K) NC NC > NC > >5 Ground Ground Ground > Ground > >6 oven mon. oven mon.. oven mon. > oven mon. > >7 +28V oven +18V oven NC > NC > >8 +28V elect. +28V +28V > +28V > >9 case ground NC NC > NC > >Hope this will help others! > >Corby Dawson >____________________________________________________________ >Click here to find the perfect picture with our powerful photo search features. >http://thirdpartyoffers.juno.com/TGL2141/fc/BLSrjpTEuJFVrwUbhZLMoWdkMvKFgvKsveMbYvndjqBMzsnp5Ao03AENzO4/ > >_______________________________________________ >time-nuts mailing list -- [email protected] >To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >and follow the instructions there. > > > > Stay connected to the people that matter most with a smarter inbox. Take > a look http://au.docs.yahoo.com/mail/smarterinbox >_______________________________________________ >time-nuts mailing list -- [email protected] >To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
