Hello Time Nuts,
I'm back again. I designed bandwidth-limited (30 MHz) ADA4899-1 opamp circuits
to buffer the 10 MHz reference, with theoretical noise of less than 3 nV/rtHz.
Oscillator noise is about -155 dBc/rtHz from 1 KHz to 10 KHz, and -160 dBc/rtHz
from 10 KHz to 100 KHz. Unfortunately the rest of the design is holding up PCB
manufacture, so results on these won't be available for awhile.
Which brings me to the other design-stopping considerations: Is anybody aware
of low-noise analog switches that can be used to reconfigure the 10 MHz
reference paths without significantly degrading the phase noise? As always, I
believe 1/F noise would be the concern. Non-reflective is great, but I can
accomplish that by using more switches and 50 ohm resistors if need be.
Isolation is a key consideration as well. Mechanical relays are out of the
question.
An alternative to switching is phase-locking the OCXO to an external
reference. I have thoroughly looked into this possibility, and it is likely my
preferred approach. But I need to understand how the switching approach
compares, hence my question. I do not need help with phase-locking; this
feature is readily available from OCXO vendors who have dedicated years of
research to optimizing their products.
Any switch experience out there?
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
