On 7/11/2011 2:54 PM, Jason Rabel wrote:
Ron,
My guess would be one of two things...
First check the EFC on the OXCO, if it's near the edge of the tuning range you
might need to adjust the Coarse Adjustment screw to
get it back to near-center of the EFC range.
Interestingly, the 14:21:14 report reports EFC: OK ... But, it is
tracking no (i.e. zero) satellites. This is a bit hard to believe as
the aerial is outdoors at the peak of my roof with a clear view of the
sky to the horizon in all directions..
Second, as Bob said, it could be the GPS receiver (I believe these had Oncore
6-channel VP receivers), or maybe even the GPS antenna
or possibly the cable run.
I am beginning to think this is a GPS receiver problem, as mentioned
above.. I'll have a watch on the status pages for a while.
The VP receivers appear on eBay every now and then. I'm *pretty* sure the
8-channel VP models can be sent a command to emulate the
6-channel models.
Are all the 6-channel oncore receivers the same (i.e. are they drop in
replacements)??
Thanks,
R
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
