Hi John,
I did you what you suggested and it locks now. I tweaked so that the output is only 10-20Hz above 10MHz. It seems to lock on the way down from the peak (high) frequency, it doesn't seem to lock on the way up. It seems to agree with one of your plots, but no the other. You don't say what he difference is between the plots. It is sensitive to vibration, it seem to unlock easily when bumped. Do you know what the other trimmer is for?

Bob


----- Original Message ----- From: "John Beale" <[email protected]>
To: <[email protected]>
Sent: Tuesday, January 03, 2012 1:29 PM
Subject: Re: [time-nuts] FE 5680a 3pay 36.89 includes shipping. Finally ordered one


On 1/3/2012 8:20 AM, Robert Benward wrote:
I got mine for around $25 in a regular bidding affair. Mine had trouble
locking, It only locked a handful of times, and that took forever, but most
of the time it just sat there and cooked. The seller replaced it and the
new locks up in 2 or 3 minutes. I did not have to ship the old one back.
The Lock output signal doesn't seem to have enough drive to turn on an LED.

One of the three FE-5680A units I got behaved exactly that way. Turns out some part of a VCXO circuit had drifted over time (I assume) so the free-running frequency never quite reached up to 10.000 MHz enabling lock to the signal from the physics package. Assuming you do have a 10 MHz output signal, put a counter on it while it is warming up and look at the frequency. After I fixed it, the frequency vs time from startup plot looked like this:
https://picasaweb.google.com/lh/photo/7E22rkh_YivyesrnTog6atMTjNZETYmyPJy0liipFm0?feat=directlink

The fix was to take off case top and bottom and tweak the trimmer cap marked C217 slightly, it is near Y200 (crystal with round PTC thermistor attached). Here's a photo of that part of the board: https://picasaweb.google.com/109928236040342205185/FE5680A?authkey=djqVhWs9LkM#5680683008490223330

Of course there may be some completely different problem with your unit, but it's something to try, if you want to open it up and play with it.

-John Beale





_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Reply via email to