On Thu, 26 Jan 2012 00:21:46 +0100
Attila Kinali <[email protected]> wrote:
> * Do NOT force the PCB out. If you need to, wiggle gently. If you have
> to use force, you've forgotten a screw.
Additional note: wiggle holding the heat spreader, not the PCB.
> If possible, i'd be interested in two Revision markings on the PCB.
> Mine has a sticker at the bottom, that reads "RevF".
> Then there is a PCB number on the top side, at the edge near the
> reference crystal (that with the PTC soldered to it). My unit reads there
> "217421-30352" "Rev G"
And a correction: the sticker reads "406" "RevF".
I think the sticker denotes the what population option was choosen,
while the PCB marking denotes the type and revision of the PCB.
Additonal note to self: do not take any device apart, when already
being half asleep. Also do not try to write emails and trying to make
any sense.
^^;
Attila Kinali
--
Why does it take years to find the answers to
the questions one should have asked long ago?
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
