The replacement display board is available for about $550. The display itself may be available if you could find the part number for about $125, but Agilent WILL NOT give the raw display part number out. I ran into this same problem with the 3458A and was finally able to find the number and order some. Does anyone on the list have the raw display part number? There is also a small chance the problem is in the HV module. Perhaps going straight to the display vendor.
Thomas Knox > From: [email protected] > Date: Fri, 2 Nov 2012 10:24:07 -0600 > To: [email protected] > Subject: [time-nuts] HP-53132A Faded and flickering display > > Dear Group, > > Good morning! I just got my first HP-53132A frequency counter and Prologix > GPIB-USB converter. Now I can do some measurements and I am excited about it. > Everything looks promising. Condition of the instrument on the outside is > like new, controls responsive and no fading in lettering at the buttons. > Connectors are not worn or damaged, original connectors. The unit has been > tested and works OK, probably not with adequate calibration but that is not > an issue now, I can always calibrate it later. > > What worries me is the display. Even though being an Agilent built unit, it > has probably more hours on it than a seldom used HP built unit. The > flourescent display is fading, not all the digits show consistent > illumination levels. The left-most digits show some flickering at some of > their segments. It is readable in the end, but I am terribly disappointed > about it. > > Does anybody know if there is a cure for this? Or should I start saving for a > better unit. > > I am not afraid of the screwdriver or the soldering iron if someones suggests > a display overhaul. Thank you! > > > Regards, > > > > Edgardo Molina > Dirección IPTEL > > www.iptel.net.mx > > T : 55 55 55202444 > M : 04455 20501854 > > Piensa en Bits SA de CV > > > > Información anexa: > > > > > CONFIDENCIALIDAD DE INFORMACION > > Este mensaje tiene carácter confidencial. Si usted no es el destinarario de > este mensaje, le suplicamos se lo notifique al remitente mediante un correo > electrónico y que borre el presente mensaje y sus anexos de su computadora > sin retener una copia de los mismos. Queda estrictamente prohibido copiar > este mensaje o hacer usode el para cualquier propósito o divulgar su en forma > parcial o total su contenido. Gracias. > > > NON-DISCLOSURE OF INFORMATION > > This email is strictly confidential and may also be privileged. If you are > not the intended recipient please immediately advise the sender by replying > to this e-mail and then deleting the message and its attachments from your > computer without keeping a copy. It is strictly forbidden to copy it or use > it for any purpose or disclose its contents to any third party. Thank you. > > > > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
