That header is used for programming the on board PIC. I've rung it out as follows: Header pin 1 -> PIC pin 18 MCLR (active low) Header pin 2 -> PIC pins 28 & 40 VDD Header pin 3 -> PIC pins 29 & 39 VSS Header pin 4 -> PIC pin 21 PGD1 Header pin 5 -> PIC pin 22 PGC1
73 Dale NV8U Sent from my iPhone On Jan 5, 2013, at 6:46 AM, "David J Taylor" <[email protected]> wrote: > Does anyone have the pin-out for the 5-pin connector on this board? The > 10-pin connector is documented, but not the single-in-line 5-pin connector > near the label HGR200 (?). I didn't see it documented in this thread either. > > Thanks, > David > -- > SatSignal Software - Quality software written to your requirements > Web: http://www.satsignal.eu > Email: [email protected] > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
