There has been a lot of speculation about the innards of the OXCO in the Thunderbolt so here is what I found inside a dead one that I opened. I didn’t trace the circuit out so most of the description that follows is just from a cursory look and may not be totally correct. Below are links to a couple of photos of the oscillator board.
The OXCO in the Thunderbolt (Trimble 37265) is a single oven unit. The circuit board is mounted on the connection pins and has fiberglass mats on top and bottom for thermal isolation. There are two +12VDC input pins, one for the oven and the other for the oscillator power. The +12V pin for the oscillator goes through a 1 ohm resistor to a 8L08A 8V three- terminal linear regulator which powers the oscillator and most of the other electronics. The ‘heater’ that is powered by a separate +12V pin is a 2N4921 transistor mounted on the copper block with the crystal and the thermistor. There is a diode between the input pin and the transistor for reverse polarity protection but not on the oscillator input pin. From reading some of the past post about people connecting the power to the Tbolt incorrectly, this would explain why the heater still works but there is no output. The 1 ohm and/or the 8L08A are destroyed while the heater circuit was protected. Other stuff on the Tbolt board probably gets destroyed as well. The crystal is marked OFCG-P, Div of Oak Ind and this one is marked 86.3C for the temperature. The oven controller is an LM358 dual OP-AMP and there is a 10-turn pot that I believe sets the oven temp. It looks like the 10Mhz output goes through a couple of transistors, a transformer, and some L-C stuff before going to the output pin. There is a SOD-323 device marked VD1 which may be a BB639 varactor for the EFC adjustment. -Arthur http://i906.photobucket.com/albums/ac262/rjb1998/OXCOinside1_zps02c43ce6.jpg http://i906.photobucket.com/albums/ac262/rjb1998/OXCOinside2_zps2b758675.jpg _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
