>> Subject: Distribution amps for Thub=nderbolt and David >> partridges divider box? >> >> 09/05/2013 11:58 >> >> If I get a Extron ADA 3-80 distribution amp, will it be able to run on >> both the 10MHz T/Bolt output, AND on the outputs of one of David >> Partridge's nice divider boxes I have. It It divides from the 10 MHz >> input. There are separate outputs for 10 MHz, 5 MHz, 1 MHz, and one >> that can be configured for 100 kHz / 10 kHz / 1 kHz / 100 Hz / 10 Hz / >> 1 Hz. >> >> If not, is there anything available? >> >> Thanks. >> >> -- >> Best Regards, >> Chris Wilson. >> mailto: [email protected] >>
> Chris, if I understand your question correctly, the answer is "Yes". The > ADA-3-80 has four separate channels (R, G, B, Sync), and multiple outputs > for each channel. So, you can input up to four separate frequencies and get > up to four outputs for each channel. Quite a versatile little box. > Cheers, > Dave M > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. 18/05/2013 23:01 I have been offered one of these: http://www.extron.co.uk/product/product.aspx?id=ada6300mxhv Specifically the model : ADA 6 300MX HV HDTV RGBHV 1 x 6 Analog Video Distribution Amplifier I *THINK* it should meet my needs except the HV bit worries me. It seems this means it has not got unity gain, but a gain of 0.7 or 1 volt, switch selectable. Could anyone comment if it's suitable to use my Trimble Thunderbolt with several pieces of test gear at the same time? Thanks. Here in the UK the ADA-3-80 seems a rare find. -- Best Regards, Chris Wilson. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
