On 7/23/13 9:15 AM, Chris Albertson wrote:
I don't think those requirements are hard.  You can build a system
that works in three cases
1) GPS is available full time
2)  GPS is available intermittently.
3) there is not GPS system, world war III has destroyed it.

or you're in an urban canyon
or you're underground
or you're working in a GPS-denied environment (battlefield scenario)



I think what you want is a system that is failure tolerant and can
make use of the best available source of timing and degrade
performance gracefully.  And you need this is be automatic with the
only control maybe being a status LED that shows free/yellow/red

I'm not sure "failure tolerance" is actually the right approach: more like selecting the appropriate mode.

There's probably no need to smoothly change between GPS available and not available, for instance, so one doesn't need some sort of optimal estimator that combines all available sources. You can just "jump"

There is a desire to leverage other assets that are available (there's already too many radios.. we don't need to add more).





Each system has a GPS receiver that disciplines a crystal oscillator.
This oscillator is used for timing.  I think it's clear that this
handles cases #1 and #2.

Then use you Blue Tooth or whatever other short distance
communications system you have to support an IP network.  TCP/IP over
zBlueTooth works well and is a standard now.  Using this you can
configure a NTP based network of "peers".  Each of the above systems,
when they are close enough will share timing with the other peers.

Time is probably not the hard part. There's tons of ways to sync to 1 millisecond, and for the ranges of interest, light/propagation time isn't an issue. The challenge is finding something that gives me the 1 millisecond without having to add some sort of hardware.

For instance, the system *is* a 3 GHz radar, and the challenge is to synchronize transmitters and receivers, but hey, the transmitter can transmit at a known time, the receiver can detect when it sees the transmitted signal. I could even modulate the transmitter.

The system runs on a "consensus time".  If one or more systems has
access to GPS those system will supply timing to  any other system in
range of the blue tooth.   If there is no GPS at all the systems will
form what they call an "orphan network" and will remain synced to each
other untill some outside source of time connects and puts them all
back on GPS time.   NTP is pretty good at handing the case where
timing sources come on and off line and where network connects connect
and then go away.  It is very failure tolerant.

Or an NTP-like algorithm that handles the communications dynamics of the system. NTP is tuned/designed for "networks" in terms of adaptation rates and the filters.




What you'd have is a kind os graceful degradation.  When GPS is
visible to all units they are all "dead-on" and running well above you
specs.  If GPS is hidden (perhaps in an urban canyon or you happen to
be inside a tunnel) the systems ail remain in spec for many hours or
even days depending on how much money you spent on the crystal  (or
Rubidium) oscillators

Power & mass is more an issue than cost, although $1000 oscillators are probably out of the question. Imagine you have to carry one or more of these things for 12 hours across a disaster site along with your other gear. Power turns into mass, too.



Finally if there is no GPS at all but several systems are within blue
tooth range that can sync to each other at the few millisecond level.
but because you did spend $$ on a god crystal will stay sync'd for
hours even when out of bluetooth range with no GPS.

Most off the shelf BT interfaces don't have timing outputs, and I'm not exactly thrilled about implementing BT from scratch. It's sort of like getting timing from Ethernet. Sure, you *could* modify a standard ethernet transceiver to be driven from a 10 MHz, or to recover 10 MHz from the Ethernet signals, and you could modify it to tag when you get a sync detect. But it's a heck of a lot easier to buy someone's PTP enabled interface.



The good thing is that you only need to integrate existing technology
to make this happen. The  software, hardware and all the parts are
available.   You'd not have to pay to advance the state of the art.

You would have to balance things like crystal oscillator stability vs.
power.  Ovenized units suck up power.  TCOXs use less power but maybe
hours and not days of hold over time is enough.

The LED's color depends on the estimated timing error, NTP is good at
computing that based on if GPS is connected and working, the network
status and so on.  So it might be green for microsecond level, yellow
for millisecond level error and red for "few seconds" level, flashing
for no-sync


In this system, the user doesn't care what the time uncertainty is. either it's good enough, or it's not.

_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Reply via email to