On 1/30/2014 7:50 PM, John Miles wrote:
Exactly, for unity gain you'd design for +6 dB and series-terminate the
output with 50R. Good for capacitive loads as well as isolation.
Do you run it in inverting or non-inverting configuration?
I've only used the non-inverting configuration (figure 1 from the
datasheet). Takes about 20 minutes to dead-bug with 0603 resistors over
bare copper.
-- john, KE5FX
Miles Design LLC
The LMH6702 has 50 dB of reverse isolation at 200 MHz (good)
but the phase noise is 15 dB above my DUT, so the search
continues.
Rick
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
