Bob wrote:
here's the result for 1PPS vs 10MHz for my GPSDO, as measured by a 5334B clocked by the same 10MHz. I don't know how to read these, but 6,3,1,6,3,1 etc. doesn't look normal.
The adev results you obtained look very much like the "adev" results reported by Lady Heather, very likely for the same reason -- you do not have any independent standard by which to measure.
From what you say above, it appears that you measured the time interval between one edge of the PPS pulse and the next zero-cross of the GPSDO 10 MHz, using a 5334B clocked by the GPSDO 10 MHz. Is that correct? I take it the GPSDO is disciplined by the PPS?
Bear in mind (i) that you are comparing one noisy source to another, and (ii) that the errors are correlated more and more strongly as tau increases beyond the point where the discipline loop begins controlling the 10 MHz oscillator. At small tau, the GPS PPS is very noisy (much noisier than the 10 MHz oscillator), and it gets better and better as you average for longer and longer periods until at tau above 10k it's reasonably decent. Your GPSDO should leave the oscillator more or less on its own at low tau (where the jitter in the oscillator is lower than the jitter in the PPS), and correct it beginning at some longer tau where the jitters are comparable (continuing to even longer tau where the jitter in the PPS is lower than the jitter in the oscillator).
So, measuring as you appear to be doing, at low tau you are essentially measuring the improvement of the PPS with averaging -- 10x per decade -- using the essentially undisciplined 10 MHz oscillator as a standard. At some point, you would expect to reach a floor where you would essentially be measuring the residual jitter in the disciplined oscillator and the PPS. In fact, you can see this in your results starting around tau = 500, but your series does not go far enough to show the floor clearly.
Bob suggested that you are measuring the trigger error of the 5334B, and that may be contributing to your results as well. With good measurement techniques, the outer bound of the 5334B trigger error should be less than 1nS, probably more like 200-300pS. Your actual error is probably significantly lower than this outer bound unless something is wrong with your setup. The trigger contribution to your computed adev should also fall 10x per decade with increasing tau.
Best regards, Charles _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
