Chris, The 10811-60165 may be similar to the HP 10811-60158 that uses using the following pin-out:
1 - BRN Oscillator Return (Com) 2 - RED Oscillator Power (+12V) 3 - ORG Oven Monitor Return (Com) 4 - YEL Oven Monitor Output 5 - GRN Oven Power (+18-24V) 6 - BLU Oven Return (Com) The following description is from the 10811 A/B Manual where the recommended oven monitor circuit is shown: The Oven Monitor Output is an indicator of oven warm-up. At initial turn-on (warmup) the oven monitor will go to approximately 1.5 volts below the oven power supply voltage. After the oven cuts back, the output will drop to approximately 3.5 volts (at 25°C). The output impedance of this circuit is 10,000 ohms. Richard > I've seen a pin-out for the outer-oven 6-position connector (2 heater wires, > 2 thermistor wires), but I've not found anything on the pin-out of the other > 6-position connector. Has anyone come across the pin-outs for the > 10811-60165 connectors? > > CS > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
