I think the solution will be in the firmware. It must be factory set so default is the 5GHz C channel option. The 12GHz option is the same part as the 5GHz sampler with a different firmware lock. Best Wishes; Thomas Knox
> From: [email protected] > To: [email protected] > Date: Tue, 18 Mar 2014 14:19:14 -0400 > Subject: [time-nuts] 3.0GHz Channel 3 installation in Agilent 53132A counter > > I hope this is not too OT. > > > > I have acquired a 3.0GHz original Channel 3 board for my Agilent 53132A > counter. When installed, it reads four times (4x) the actual frequency. > I'm wondering if anyone has any experience with such an installation and can > point me to some setup item or zero ohm resistor I'm supposed to install. > All that the manual says is to have it done by the factory. That will cost > me more than the board itself. Many thanks. > > > > Jim Robbins > > N1JR > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
