Hello to the group I would agree its coax. But also the n connector to the right can take DC in and power the splitter. So if your rcvr puts out 4.5-30V you are in business. I say this from the internal pix you posted of the unit. That was very helpful. Regards Paul WB8TSL
On Sat, May 9, 2015 at 3:15 AM, Hal Murray <[email protected]> wrote: > > [email protected] said: > > Anyway, I'm not too proud to admit that I'm not familiar with the power > > connector that apparently comes with the 05Q option. I have a link > below to > > a couple of pictures. Maybe I missed something obvious when poking > around > > on the internet for documentation, but I can't find anything that > describes > > this connector. I assume it is stock? The +DC input pin/wire can be > seen > > just inside the white tube... again, maybe this is obvious to real > > time-nuts! I'm working on that time-nut thing! > > The white tube looks like insulation from coax. Have you tried taking the > connector apart? > > You might poke around with an ohmmeter. It looks close to setup to take > power from the lower right output connector. Adding a few parts may switch > it back to that mode. > > > -- > These are my opinions. I hate spam. > > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
