Hi all, I have developed an upgrade kit for the HP5065A. This add one or two 10MHz outputs and can be installed in all the units have the HP10811 as OCXO.
The main features of this amplifier-separator are: Very low residual phase noise, typical -150dB @ 1Hz High reverse isolation typical 110 dB High input impedance do not load the HP10811 output High output power handling on 50 Ohm settled to +15dBm (as the others HP5065A outputs) Output GND isolated to avoid the low frequency current loop The Option H10-1 have one single 10MHz output The Option H10-2 have two separated 10MHz outputs The option is assembled ready to install and is complete of all the connectors, cables and others components are needed. You can find the installation manual with pictures here: http://www.timeok.it/files/hp5065AoptH10v101.pdf Visit also my HP5065A corner here: http://www.timeok.it/HP5065_corner.html If you are interested, please email me: [email protected] Best regards, Luciano _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts [1] > and follow the instructions there. Message sent via Atmail Open - http://atmail.org/ _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
