The Oncore driver can load certain parameters (e.g. the fixed location, mode of operation, and -- I think -- the current estimated time) into the Oncore receiver's RAM, but doesn't do anything to the firmware on flash.
Cheers! -Pete On Sun, Jun 21, 2015 at 1:06 AM, Hal Murray <[email protected]> wrote: > > [email protected] said: >> I didnt see this well answered - the device loads firmware at each start >> cycle. If i am not mistaken you can even use ntp. > > I just scanned the ntp source code for the Oncore driver. I didn't see any > hints of loading firmware. There is code to read the firmware version. > > -- > These are my opinions. I hate spam. > > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. -- Pete Stephenson _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
