In the early 1970's both LED and LSI integrated circuit technology advanced to the point that digital wristwatches were introduced. These used 32,768 Hz crystals. Use of this technology was made in digital desk clocks (such as alarm radio clocks), but I think that for many years it was much less expensive to use the AC line as a frequency standard. Early Mostek clock IC's used the 50/60 Hz powerline as the reference and didn't include provisions for a crystal.
The first digital clock I owned was a flip card clock radio in around 1970. An AC line powered synchronous motor slowly flipped minute and hour cards. A few years later I had a Radio Shack LED wristwatch. I see that 32,768 Hz crystals can now be purchased for US $0.15 each in lots of 100. -- Bill Byrom N5BB On Sun, Jul 26, 2015, at 07:08 PM, Dave Martindale wrote: > It's not just synchronous-motor clocks that use line frequency as a time > reference. I have a Heathkit alarm clock that counts cycles of line > frequency as its timebase. I think that was common in the early > generations of NMOS clock chips. The clock does have a backup oscillator > (powered by a 9 V battery) for use when line voltage disappears, but its > accuracy is horrible. I think it's an RC oscillator, and in a power > failure of a few hours it will accumulate minutes of time error. > > So a bunch of people with analog and digital clocks from that era are > likely to notice the drift, particularly at 20 minutes/year. > > When did 32 kHz crystals get cheap enough that line-powered clocks > started > using them as a time reference instead of counting line cycles? > > - Dave > > On Sun, Jul 26, 2015 at 2:25 PM, Bill Byrom <[email protected]> wrote: > >> >> 60Hz Stability on Power Grid Going Away? >> >> http://www.radiomagonline.com/deep-dig/0005/60hz-stability-on-power-grid-going-away/33527 >> >> NERC Frequency Response Standard Background Document >> >> http://www.nerc.com/comm/oc/rs%20landing%20page%20dl/related%20files/bal-003-1_background_document_clean_20121130.pdf >> >> It appears from various comments that with no manual time correction, >> the accumulated time error in the East Interconnection will typically >> gain 20+ minutes/year. The West will gain 8 minutes/year and ERCOT >> (Texas area) will gain 2 minutes/year. >> >> http://www.ercot.com/content/meetings/rms/keydocs/2011/0518/03_manual_time_error_correction_elimination_field_trial.doc >> >> So don't trust an AC synchronous motor clock in North America. >> >> -- >> Bill Byrom N5BB >> >> > _________________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
