Thanks to Paul, the Lucent is now reporting UTC. Apparently, even
though the Status screen says UTC, it doesn't really change until
after a power cycle. Bad UI.

My Z3801A is off at the moment and about to go onto the bench, so I
compared against: http://time.is/UTC

Joe Gray
W5JG


On Thu, Mar 17, 2016 at 7:27 AM, Paul <tic-...@bodosom.net> wrote:
>
> On Wed, Mar 16, 2016 at 8:29 PM, Joseph Gray <jg...@zianet.com> wrote:
>>
>> I noticed on the Status screen that the Lucent unit said the PPS was
>> locked to GPS, not UTC, as the Z3801A is. So, I issued ":DIAG:GPS:UTC
>> 1" and "TST?" to correct this.
>
>
> I have a collection of notes about the Lucent at http://do-nyc.bodosom.net.
>
> As previously noted the relevant bits are:
>
> :DIAG:GPS:UTC 0|1 (0 GPS, changing time scale happens after reboot e.g.
> :syst:pon)
> :DIAG:GPS:UTC? (Reports new value immediately on change)
> ...
> :SYSTem:PON (reset the unit as opposed to the normal use of this command)
>
>
>
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Reply via email to