Hi
> On Nov 9, 2016, at 6:28 PM, Bob Stewart <[email protected]> wrote: > > Tom, > How many times have people posted here, on time-nuts, not to trust the > trailing edge of a 1PPS pulse? The rest of the caution is : The leading edge is the one that is “on time” and the second edge is an unknown offset from it …. If you have something made back in the 1950’s you might have an issue with an analog one shot. Bob > > Bob ----------------------------------------------------------------- > AE6RV.com > > GFS GPSDO list: > groups.yahoo.com/neo/groups/GFS-GPSDOs/info > > From: Tom Van Baak <[email protected]> > To: Discussion of precise time and frequency measurement <[email protected]> > Sent: Wednesday, November 9, 2016 4:44 PM > Subject: Re: [time-nuts] How to get PPS from ublox mini-PCI GPS to APU2 SoC > serial port for ntpd > > Bob, > > The PIC's I use have essentially no jitter. If they generate a 1PPS the edge > and the pulse width are perfect, down to picoseconds. The talk about "other > stuff" and "priority" and "number of compares" and "ambiguity" is worrisome. > It sounds like a design or coding flaw to me, like what happens when people > try to do precise time with a high level language. > > /tvb > > ----- Original Message ----- > From: "Bob Stewart" <[email protected]> > To: "Discussion of precise time and frequency measurement" > <[email protected]> > Sent: Wednesday, November 09, 2016 9:30 AM > Subject: Re: [time-nuts] How to get PPS from ublox mini-PCI GPS to APU2 SoC > serial port for ntpd > > > I'd like to comment on the idea of measuring the width of the pulse. My > experience with creating the 1PPS from an interrupt is that it's fairly > straightforward how to do the set interrupt: The interrupt happens, you > execute one, maybe two instructions to raise the output pin, and you leave > the interrupt routine. But, resetting the pin is a different story. Unless > you've got a lot of interrupt vectors to play with, the reset part of the > 1PPS signal is delegated to a general purpose timing interrupt where you're > doing a lot of other stuff - and it has a somewhat lower priority. So, you > wind up doing a number of compares to see if you should reset the pin, which > adds some ambiguity to the set/reset times. > Granted, I'm doing this on a general purpose PIC, but I have read comments > about various receivers having some jitter on the reset side of their 1PPS > pulse. > Bob > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
