amazing. especially after a week of effort.
thank you. dave On Sat, Apr 22, 2017 at 12:30 PM, Dave Mallery <[email protected]> wrote: > Hi Mark > > I was delighted to read about Heather's ability to talk to a timing M12. > I have been having fits here trying to get the M12 to accept any command > (using Perl.. a mistake it seems). i wanted to end up with a Linux capable > utility and had previously used Perl to parse NEMA on my old TAC2. > > I have been learning about binmode(M12) and other edge cases, but am > probably still far from the eureka moment.. > > anyhow, i am setting up heather5 for a trial flight. > > thanks > > dave mallery > > > > On Fri, Apr 21, 2017 at 8:40 PM, Mark Sims <[email protected]> wrote: > >> Earlier somebody asked if these were M12's or M12T's. I powered mine >> up and connected it to Lady Heather. It appears to be an M12T. It >> responds to the survey and position hold commands and outputs the sawtooth >> correction value. Also the hardware ID returned is P373T12T12. >> _______________________________________________ >> time-nuts mailing list -- [email protected] >> To unsubscribe, go to https://www.febo.com/cgi-bin/m >> ailman/listinfo/time-nuts >> and follow the instructions there. >> > > > > -- > Dave Mallery, K5EN (ubuntu linux 16-10) > PO Box 15 Ophir, OR 97464 > > linux counter #64628 (since 1997) > > > > -- Dave Mallery, K5EN (ubuntu linux 16-10) PO Box 15 Ophir, OR 97464 linux counter #64628 (since 1997) _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
