Pretty sure that connector is an off the shelf Amphenol part. If you can't find it, however, you can replace it with an off the shelf one that will fit in the same hole. (If your lucky, you can even re-use the pins.)
The replacement will run you about $30-40 for the pair, chassis and plug. Check Mouser, etc. > On May 19, 2017, at 23:21, Bob kb8tq <[email protected]> wrote: > > Hi > > The mating side of that 22 pin connector isn’t going to be cheap. It looks > like something out of their > government systems group back in the late 90’s. If it is, you may have a hard > time getting info on it. > I’d pop it open and see what’s inside. At least that will give you an idea if > it’s 20 years old or 5 years > old. Knowing the era should help in the search for information. > > Bob > >> On May 19, 2017, at 10:21 PM, Scott Armstrong <[email protected]> wrote: >> >> Hello all, >> >> I acquired a Trimble 16634-10 receiver. A search of the web has turned up >> nothing so far. >> The unit is in a steel box built like a tank. SMA connector for antenna >> input and a 22 pin circular connector for the I/O and power >> >> Does anyone have any pin out information, specs, etc.? >> >> A picture of the unit can bee seen on ebay at >> >> http://www.ebay.com/itm/TRIMBLE-NAVIGATION-GPS-UNIT-16634-10-/361934484802?nma=true&si=8bBNGShIPf%252FvJpucfMDlEGXDrwI%253D&orig_cvip=true&rt=nc&_trksid=p2047675.l2557 >> >> >> Thanks in advance, >> >> Scott AA5AM >> _______________________________________________ >> time-nuts mailing list -- [email protected] >> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
