Seems like I have more than one problem.

Did a voltage check on the Antenna Input BNC and got zero !!


Thanks for the reply,


73, Dick, W1KSZ


Sent from Outlook<http://aka.ms/weboutlook>
________________________________
From: time-nuts <[email protected]> on behalf of Bob kb8tq 
<[email protected]>
Sent: Saturday, August 26, 2017 7:06:57 AM
To: Discussion of precise time and frequency measurement
Subject: Re: [time-nuts] TrueTime XL-AK Questions

Hi

The older GPS units had a downconverter in the antenna and passed an IF 
frequency
back to the receiver. There also was an era when the standard antenna was fed 
12V
(rather than 5V) and had 50 db of gain (rather than 20 to 30 db). Most modern 
hockey
pucks will be unhappy with 12V.

Bob

> On Aug 25, 2017, at 6:13 PM, Richard Solomon <[email protected]> wrote:
>
> I was given two of these about 20 some years ago. At that time they both 
> worked
>
> fine, except the "keep-alive" batteries were quite low. But they did lock up 
> to the
>
> GPS Satellites.
>
>
> I pulled one out today to try out (slow day !!) but I had this nagging 
> feeling that
>
> they required a different antenna than the run of the mill GPSDO. I have one 
> of
>
> the e-Bay "hockey puck" antennas hooked up to it and the status window says
>
> ..."looking for satellites"... .
>
>
> Do the TrueTimes require something special in an antenna ?
>
>
> Thanks, Dick, W1KSZ
>
>
> Sent from Outlook<http://aka.ms/weboutlook>
> _______________________________________________
> time-nuts mailing list -- [email protected]
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.

_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Reply via email to