hi i was prepping for some machine shop work on a heatsink for the SA22.c.
there seems to be an error in the designers reference and user manual on page 22. the bottom view drawing at the far low right shows a measurement of the distance between the edge of the board and the hole just below and to the right of the SAMETC connector... it shows a distance of 15.95mm. my measure is about 25mm...that's measured on the development board. YMMV thanks dave On Sun, Aug 27, 2017 at 7:57 AM, Dave Mallery <[email protected]> wrote: > hi mark et al... > > i was lucky enough to bet that that card was an sa22.c development board > and got one. > > ordered the sa22 and please point me at the code as it develops. > > thanks! > > dave > > On Fri, Aug 25, 2017 at 6:09 PM, Mark Sims <[email protected]> wrote: > >> I got in a SA22.c rubidium from RDR electronics and one of those >> interface boards that appeared briefly on Ebay last week (he had 6 for $7 >> each and they went fast... there is another seller that has one for $80). >> The X72 code that I added to Lady Heather works with the SA22. I'm still >> working on improving the software disciplining algorithm. >> >> If you bought one of those adapter cards note that you will need a F-F >> adapter to use them with a standard serial cable. Since the adapter has a >> male connector, I thought it needed a null modem cable... nope... just >> more Symmetricom ridiculousness at work... >> _______________________________________________ >> time-nuts mailing list -- [email protected] >> To unsubscribe, go to https://www.febo.com/cgi-bin/m >> ailman/listinfo/time-nuts >> and follow the instructions there. >> > > > > -- > Dave Mallery, K5EN (ubuntu linux 16-10) > PO Box 15 Ophir, OR 97464 > > linux counter #64628 (since 1997) > > > > -- Dave Mallery, K5EN (ubuntu linux 16-10) PO Box 15 Ophir, OR 97464 linux counter #64628 (since 1997) _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
