On 9 February 2018 at 21:43, John Green <wpxs...@gmail.com> wrote:

> To those who doubted that the antenna was actually a 3.3 to 18 volt design,
> it seems you were correct. Today, I hooked it up to a variable power supply
> and slowly raised the DC voltage fed to the antenna. It began to pull
> current at about 2.9 volts and at 3.3 volts, took about 40 mA. I continued
> to slowly raise the voltage. At about 7.5 volts, the current suddenly
> dropped to 10 mA. At just below 12 volts, it suddenly increased to 80 mA
> and the supply went into current limit. I increased the current limit to
> 130 mA and repeated the exercise. Everything went as above until I reached
> 12 volts and the current went to 130 mA and the supply went into current
> limit. Lowering the voltage didn't lower the current. I disconnected it,
> waited a minute, and tried again. Yep, shorted. It would have worked well
> with the T bolt, but would have blown anyway if I tried to use it with my
> 12 volt supply and bias T. I guess I will get inside it somehow to see if
> it can be repaired. My first attempt ended in failure. I guess I need a
> bigger screwdriver with which to pry the top off. I am going to contact the
> seller and tell them it was not as advertised. I kind of doubt that will
> get me anything, but it won't hurt to try. There is a saying about
> experience being a cruel teacher. You get the results first, and the lesson
> after. Oh well.
>


You should not open it up, but open an eBay case for item not as described.
If it said it would do 3-18 V, but does not, then its not as described, and
you should get your money back. The chances are the seller will not want to
arrange collection, so you will probably get to keep it anyway. But you
should get a refund before opening it up.

Dave
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Reply via email to