Hi, On 07/04/2018 05:19 AM, Ryan Stasel wrote: > Hi All, > > I see a couple hits in google for this being discussed before, but they’re > being shown as not found on febo.com<http://febo.com>. =/ > > I’m curious if anyone has done work on getting something like a raspberry pi, > Arduino, etc running ntp or ptp (possibly sync’d with a 1PPS signal) and > outputting SMTPE over audio, or some GPIO pins. I have a studio clock (Leitch > 5225) that can be sync’d over SMPTE (or EBU). I will admit I’m still trying > to digest all of this, but this seems like it should be possible. > > Basically, I’m trying to make build a DIY master clock similar to one of > these: https://www.masterclock.com/products/time-code-generators/gps500 > > Thanks!
OK, it is not too hard to code it up. I did it for IRIG-B, and it's possible to do for SMPTE 12M LTC code too. Validating it is however something that needs care. Cheers, Magnus _______________________________________________ time-nuts mailing list -- time-nuts@lists.febo.com To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com and follow the instructions there.
