Hi Tom,




Ok and stable were referred to the general behavior of the unit (PSU voltages, 
current draw).



After a 2 h warmup I've run the following test:



Frequency has then been measured with the aid of an HP 5345 clocked to a 
Efratom MFST GPS+Rb and is stable.



Phase noise is just around -135 @ 100 hz, output power is 10 dBm.



I did not run a full test since I have to be sure that the clock is "safe" in 
term of leaky capacitors

And so on. Leaving a 44 Year instruments running unattended in the lab after 20 
years of sleep

Does not sound very safe to me :)



During the weekend I'll try to keep it running for 48H so I'll see what will 
happen.



In the meantime, thanks for your help!





Ciao,

Giorgio.





> i have been lucky to found a working Oscilloquartz 3210 Cesium ( warehouse of 
> a telco operator ) in a good shape.



Nice find. The OSA 32xx manual that I scanned is at:



http://leapsecond.com/museum/osa3200/



That's 33 pages of "Operating and Instruction Manual". If your unit is working 
within spec, that's sufficient. I'll check if additional manual pages are 
around here somewhere, in case you need to repair it.



> seems ok and stable



Words like "ok" or "stable" are vague; try to give numerical measurements for 
accuracy and stability. That will help determine if your vintage Cs clock is 
actually working to spec or not.



Also log values over time. The ion pump should not have been zero if the unit 
was sitting in a warehouse for 20 years. But after some hours or days, yes, it 
could be near zero and this might be a good sign.



For an old, surplus, vintage Cs standard, its best to carefully monitor 
everything immediately after power up and continuing for several hours or days. 
The trend lines will tell you a great deal about the condition and prognosis of 
the instrument.



/tvb





----- Original Message -----

From: "Giorgio Barinetti" <giorgio at 
barinetti.it<http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com>>

To: <time-nuts at 
lists.febo.com<http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com>>

Sent: Wednesday, July 11, 2018 3:17 PM

Subject: [time-nuts] Oscilloquartz 3210 Cesium Standard Schematics





> Hi Guys,

>

> i have been lucky to found a working Oscilloquartz 3210 Cesium ( warehouse of 
> a telco operator ) in a good shape.

>

> Powers up, seems ok and stable ( capacitors on the unit has 10/1974 date, so 
> very old unit, serial 83), but the signal

> From the preamplifier is a little low and the Ion Pump current is 0. Like the 
> 3 Kv supply is low ?

>

> Like to investigate but it will be nice to have a schematic.

>

> I've found a 2014 message where Tom was willing to scan the remaining part of 
> the manual, so I'm kindly asking :)

>

>

> Thanks,

> Giorgio Barinetti

_______________________________________________
time-nuts mailing list -- time-nuts@lists.febo.com
To unsubscribe, go to 
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.

Reply via email to