Corby thathas got to be the most expensive fault detector I have run into. But great to hear. Heck 5 MHz is DC.
Paul WB8TSL On Fri, Aug 24, 2018 at 1:40 PM, <[email protected]> wrote: > Well after a lot of monitoring found the 5Mhz isolation amp feeding the > multiplier to have an intermittent output. > > Bypassed it using one of the iso/amps that feeds the front panel jacks. > > Parts on order before I pull it. > > I did make an interesting use of two HP5065A I have cooking on the bench. > :) > > Needed to monitor two 5Mhz signals simultaneously from the maser for very > intermittent dropouts. > > Fed each 5Mhz into the DIV cable from the A10 assy. on each 5065A and > manually started the 1Mhz dividers. > > Then if a 5Mhz drops out the 1Mhz dies and wont return until reset. > > After two days caught the problem with the output of the iso/amp > faulting its 5065A and the input to the iso/amp not faulting its 5065A! > > PIX of temperature controlled RF head and the two 5065A attached. > > Cheers, > > Corby > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to http://lists.febo.com/mailman/ > listinfo/time-nuts_lists.febo.com > and follow the instructions there. > > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com and follow the instructions there.
