Hi The Thunderbolt actually is not a real good solution if you want to synchronize to something other than GPS. It depends on direct phase data from its internal GPS chip set to do the GPSDO magic. A board that has a PPS signal between the GPS and “PLL” probably is a better way to go.
Even with a board that has a PPS internally, it’s not going to like an abrupt phase change between GPS and “something else”. It needs some customization of the firmware to handle this kind of transition. That makes your project more of a “from scratch” kind of thing …. Bob > On Oct 24, 2018, at 5:02 PM, Ferran Valdés <van...@hotmail.com> wrote: > > > Hello everyone ! I am new in here. I got referred to time-nuts by a > colleague, and after reading a bit, I think that is the right place for this > kind of questions :) > > I have in mind a project which consists in synchronizing two or more stable > clocks (OCXO) disciplined by GPS. > > However, would be great to have the option to disable the GPS on both sides > at a given time and to synchronize them in a Master-Slave or directly by > means of a protocol they could correct each other and synchronize themselves. > > After some research, the Trimble Thunderbold board got my attention, as has > everything I need to get the project started. > > Before getting a pair of the boards, on the datasheet is explained that one > can get the unit on a disconnected state and adjust the ADC which drives the > OCXO directly (that’s one of the desired capabilities !). > > The question is: does anybody know if the phase difference (input of the PLL) > can be read, in order to know how to steer the ADC ?? > > Alternatively, could you please suggest another board that would fulfil the > following? > > - GPS can be disabled. > - has a serial com port, so commands can be sent to the unit and information > can be retrieved. > - provides 1PPS and 10MHz signals. > > Thank you very much for your attention, > Ferran > _______________________________________________ > time-nuts mailing list -- time-nuts@lists.febo.com > To unsubscribe, go to > http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@lists.febo.com To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com and follow the instructions there.
