On 12/5/18 5:39 AM, Poul-Henning Kamp wrote:
--------
In message <[email protected]>, jimlux writes:
If I were decoding WWVB to start, I'd break my samples up into 0.1
second or 0.5 second chunks and process them to see what the carrier
phase is.
With stable signals like this, it is a bad idea to chop them up,
in particular if your ADC runs from a good stable frequency.
True enough - this was just to get started.
Instead continuously average the square of the signal into a 1
second long circular buffer.
Then multiply/sum that buffer with a 120kHz sine and cosine to find
the phase angle.
yes.. assuming your ADC is running off a sufficiently stable source. I
was thinking about a very low cost implementation where the ADC is
running off a not very wonderful microcontroller clock.
Next find the amplitude modulation in the buffer with simple
thresholding and you now know the start of the second and the
60KHz phase, so you can lock a PLL to the carrier directly,
and having done so, the phase modulation falls right out by
simple multiplication.
That would be the standard Costas loop approach - I wonder though, is
the signal strong enough that you can just clip it to remove the AM or
implement some sort of software AGC?
All manner of PLLs don't work as well when the input signal is of
varying amplitude. Maybe it works well enough here.
The really interesting thing is that you can track a lot of carriers
this way using the same single circular buffer.
If you multiply it by 77.5 kHz sine+cosine, you get DCF77 phase
and amplitude. If you multiply it by 198kHz you get...
yes..
There's some very old plots here:
http://phk.freebsd.dk/loran-c/CW/
The real intent was to show that you can do the processing with a very
simple implementation - no need to fire up SDR# or gnuradio.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
