Looking for guidance. I tried to piece together parts from the Lady Heather Readme, the heather.cpp comments, and the mailing list archives, but since it's all bit and pieces, I want to make sure I'm piecing said pieces together correctly!
I have a Trimble Thunderbolt E that I bought many years ago that has been sitting in a box. It's been out of the box once or twice for quick testing, but I wasn't able to get a good enough fix and so it went back into the box. Forward until now and I finally have a decent antenna mounted and everything working. The firmware been updated to a lot something somewhat recent. I hooked everything up, ran Trimble Studio to verify a fix and set the cable delay. I then checked that Lady Heather worked and let everything sit for about a week or so. After that week, I believe the correct procedure is: - Set the elevation mask angle to 0.0 (fe, 0.0) & signal level mask to 1.0 (fl, 1.0) - Clear and let run for a 6-12 hours (cm) - Run a site precision survey (/sp=96) - Autotune the DAC (&a) - Save to EEPROM (ee) Is there anything else that I'm missing? Do I have the order correct? I also have a Motorola M12+-based CNS Clock & a Ublox NEO-M8T to do after the Thunderbolt E. I assume that the procedure is mostly similar for those? Thanks for the pointers, and sorry if any of this falls under the "stupid questions" section! -Dustin _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com and follow the instructions there.
