Are you connecting to the “Serial Interface Setup” port which should be the closest DB9 to the right side rear of the chassis.
On Fri, Feb 8, 2019 at 17:04 David Howells via time-nuts < [email protected]> wrote: > Hello. I have a Spectracom 9189 for which I need to configure - but do > not have the password. I am able to communicate with the unit via RS232 > and terminal emulator but I am stuck in "user level" mode. If I try to > login with the default admin password (as per manual) the login fails > due to the wrong password. If, as per the manual, I enter 'defaults' at > the login prompt - that too is rejected. Does anyone have any ideas? > Surely the manual cannot be wrong? I am definitely connected to the > correct serial port. The only big difference, contrary to the manual, > is that the unit never presents me with a "login" prompt - I have to > enter "login" followed by username and password - or put another way, it > boots and is already at user level login. > > Thanks for any help - it would be great to get this unit back up as a > Stratum 1 NTP server :-) > > David. > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com > and follow the instructions there. > -- Joe Dempster +1 908 413 2889 (m) _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com and follow the instructions there.
