Hi Bob,
Do you say that you managed to get a external frequency input?
Or is it a timestamp input?
Cheers,
Magnus
On 2019-02-13 00:18, Bob kb8tq wrote:
Hi
The inability to switch the ext input over to time mode may be why they
are still working on the F9T. I have gotten mine to work, darn if I remember
how I did it :) I seem to recall it is wired / config’d someplace odd on the
Sparkfun board. (like it measures the pps output maybe ….).
Bob
On Feb 12, 2019, at 5:19 PM, Mark Sims <[email protected]> wrote:
Hopefully if Sparkfun does a F9T, they will bring out a pad for TIMEPULSE 2.
On the F9P, I have been unable to change the settings for TIMEPULSE2... maybe
the F9P does not actually support it even though is is mentioned in the docs.
Sparkfun has their SPARKX division that does short runs of boards that are
experimental or not mass-market devices... they might do an F9T that way.
Maybe some time-nut suggestions will influence them to do a F9T.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
