Thank you, Mark.
That worked beautifully. BTW, for my unit and taste, a value of 45 was the best
compromise between contrast and viewing angle. The latter changes with contrast.
Wes
On 10/3/2019 3:54 PM, Mark Sims wrote:
The command $Cxx* will set the contrast. xx can be 00 to 63. Ignore the
measurement data that the FA2 sends continuously and just type over it (or
disconnect the input signal). It should respond with something like CONTCOK
if the command is accepted. Note that the value is stored in EEPROM and there
is no way to read back the current setting.
Note that the FA2 (rather weirdly) uses the '*' character as the end-of-line
character when sending commands instead of the much more rational carriage return
key... perhaps China has a shortage of <CR> keystrokes ;-)
I am currently adding the various FA2 config commands to Lady Heather.
---------------
I am able to connect using USB and tried Putty in serial mode. When I connect
the port, the FA2 dutifully starts outputting the measured frequency but that's
the extent of my control, or lack thereof. Has anyone more skilled than I done
any programming?
_______________________________________________
time-nuts mailing list -- time-nuts@lists.febo.com
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@lists.febo.com
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
