If you're doing beam forming, the "one amp driving multiple loads" approach is probably going to do the best and most stable job of getting what you need. And all your loads should be identical, not some mix of different makes/models.
But you will need to find an amplifier that can deliver the goods (low output Z and adequate power level) with fairly low distortion as well. Perhaps a good fast opamp with a buffer on its output to help supply the high current needed to drive multiple loads at once. Dana On Wed, Oct 23, 2019 at 12:01 PM Bill Dailey, MD, MSEng, MSMI < docdai...@gmail.com> wrote: > I am working in a project that requires me to have very similarly phased > 10mhz references (beamforming). > > Previously I just used splitters for 10MHz but now I am graduating to a > distribution amplifier. Looking for suggestions/recommendations and what I > should consider. Distributing a Fury or a manually set 1111a (May have the > numbers wrong on this) oscillator. > > 1. TADD-1 x 2 > 2. 5087A > 3. 58502A > > 2&3 are from the usual auction site and may have problems now or in the > future. > -- > Doc > > Bill Dailey > KXØO > _______________________________________________ > time-nuts mailing list -- time-nuts@lists.febo.com > To unsubscribe, go to > http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- time-nuts@lists.febo.com To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com and follow the instructions there.