Yo Bubba Dudes! Thanks to E W Kehren, he sent me the data logger details from Jureg. They are attached below. If it gets screwed up by yahoo mail, I'll make a PDF.
SDData Logger for FA-2 https://www.sparkfun.com/products/13712 SDLogger - Open Hardware Data Logger - Seeed Wiki Ebay: Search OpenLog Connection: Gnd free plug behind the LCD → OpenLog Blk +5V free plug behind the LCD →Switch → OpenLog VCC Data FA-2 U13 R59 → OpenLog RX (thin wirewrap wire through unusedhole from bottom of boardupwards) Montage: Rectangularcut-out at the FA-2 back side 4mm x16mm, 3.2 mm hole over cut-out (the exact position depends on the hexagon bolt) 6mm hole for the switch Thereare no mounting holes on the OpenLog board. I glued a hexagonal bolt (M3 10mmlong) with Araldit (2 componentadhesive) onto the processor. MicroSD Card Config.txt Write 9600,26,3,0 into a txt file with an editor. Savethis as Config.txt on the SD card. Inthis log mode a new log file is created on every startup (LOGXXXXX.txt). Forother operating modes see the descriptions at Sparkfun or Seeedstudio. Regards, Perrier _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com and follow the instructions there.
