Hi All,
Just to clarify, the PLL we're looking for only needs to do the 10 ->
125MHz. The 125 ->MHz 3.125GHz is in a separate device with it's own
PLL. I have some, but not a lot of control over that. The goal here is
to provide a good source for the 125Mhz, for not a lot of board space
and not a lot of BOM cost.
Again, I apologize as this is a bit vague. Basically we're trying to
provide a "as good as reasonably possible" 125Mhz source from a VCXO, in
a relatively small (1 to 2 sq inches) board space, for not a lot of cost
($25 to $50 range).
Anyway, There have been some good suggestions here, and a few off line also.
Thanks!
Dan
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
