Hi What are you driving?
Most “normal” gear is pretty happy with a fairly wide range of input levels. Obviously things like termination and long lengths of coax can get into the act. For 4 outputs, a passive splitter with 6 db of loss should do just fine. You have only taken the output voltage down by 2:1 …. Just for reference: https://www.avionteq.com/Document/53131A-specification-sheet.pdf <https://www.avionteq.com/Document/53131A-specification-sheet.pdf> Calls out a 200 mv to 10V RMS input level as acceptable For a variety of reasons, 10V RMS is a really bad idea (cross talk ….). Lower is better in this case. Bob > On Jan 21, 2020, at 4:19 AM, skipp isaham via time-nuts > <[email protected]> wrote: > > Hello once again to the Group, > > May I ask what the current relatively simple options are for > expanding a Thunderbolt or equivalent... output for distribution > to multiple devices? > > Although I expect only two or three isolated / buffered outputs > will be required in my example. I'm worried about signal level > if a passive system (Mini Circuits divider or equivalent type) > is used. > > Would appreciate a few quick opinions on what is practical and > seems to work well. > > thank you in advance > > regards, > > skipp > > skipp025 at yahoo dot com > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com and follow the instructions there.
