On 2/6/20 3:14 PM, Will Kimber wrote:
Hi,
Usual (best?) is supply slight over voltage and use LDO/RC filtering in
each unit as Bob suggested. But that would require either supplying
24v/12v/5v/-12v (with some margin 10%?) or converting some single supply
of 24v or 48v in each unit to required voltages at each piece of
equipment. The later requires switching supplies to get all voltages.
Well that was the strategy used on S-100 boards. Bulk 8V unregulated
supply regulated down to 5V on the board.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
