I bought one the moment information about this PS was posted here.
Will you gentlemen come up with a testing method? I have an audio FFT,
spectrum analyzer up to 26.5GHz, O'scope of various kind, measuring receiver,
frequency counters, 6 1/2 DMM and other assorted stuff to play with. I,
however, lack the experience and technique most of folks here have.
I'll be glad to run any test and post a result.
---------------------------------------
(Mr.) Taka Kamiya
KB4EMF / ex JF2DKG
On Monday, May 18, 2020, 1:49:04 PM EDT, jimlux <[email protected]>
wrote:
On 5/18/20 10:19 AM, Joseph Gwinn wrote:
> On Mon, 18 May 2020 12:00:02 -0400, [email protected]
> wrote:
> Re: time-nuts Digest, Vol 190, Issue 30
>
>> Message: 1
>> Date: Sun, 17 May 2020 12:53:42 -0600
>> From: Eric Scace <[email protected]>
>> To: Time Nuts email list <[email protected]>
>> Subject: [time-nuts] potential low-RFI power supply
>> Message-ID: <[email protected]>
>> Content-Type: text/plain; charset=utf-8
>>
>> Pro Audio Engineering announced a sale (through Friday) on its
>> nominal 14 Vdc 4A switching supply
>> <https://proaudioeng.com/products/pae-kx33-low-rfi-ac-power-supply/>.
>> The test results
>> <https://proaudioeng.com/products/pae-kx33-low-rfi-ac-power-supply/>
>> webpage compares noise on the DC output and noise frequency spectrum
>> under a variety of conditions with a lead-acid battery, an Astron
>> linear supply, and a variety of switching supplies from other
>> manufacturers.
>>
>> I have not used this and can?t vouch for its performance. Given
>> recent discussions here on supplies, the analysis might be
>> interesting. At least the supplier has attempted to quantify the
>> performance of its power supply and make that information available
>> to the prospective purchaser.
>>
>> It would be interesting to see comparable (or more suitable)
>> measurements made by others posted here.
>
> Given that this power supply is intended for audio applications such as
> mixer boards, if the switching frequency exceeds say 200 KHz, none of
> the ripple spurs will matter, as they are far above the band. Hmm.
> Unless that get too close to the sampling rate of some delta-sigma
> converter I suppose.
Actually, it's intended as a power supply for HF transceivers, so noise
in the HF band is of interest. Especially if it's radiated from the
power cable.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
