Very good! I learned a bunch of things! My suggestions for the earlier parts of the presentation: - The discussion at the end of the "Types of Noise" slide should be earlier, very near the beginning of the presentation. That is, start by giving Context for why metrology has special requirements compared to other electronics disciplines, and describe those requirements in general terms (i.e. long-term measurements). THEN discuss the details of the different types of noise, etc. [Also, the word "limited" is misspelled on the Types of Noise slide.] - Similarly, for "Measurements in the Past vs Today" - this is good context that should be discussed earlier. - At the beginning of the DMTD section, again add context for "What is the problem that we are solving?", and "Why is Noise relevant to this problem?", and "Why is DMTD a good example of the problem?", etc. This may be "obvious" to an expert like yourself, but it was not obvious to me. - "Epilogue" is misspelled in the header.
Pete On Tue, Jul 7, 2020 at 10:59 PM Attila Kinali <[email protected]> wrote: > Moin, > > As some of you know, I have been allowed to give a tutorial on low noise > electronics > for this year's IFCS. As the whole conference has been turned into a > virtual one, > we were asked to record our tutorials and upload them. Additonally to the > conference > I decided to put my tutorial online for everyone to watch. You can find it > at > http://time.kinali.ch/ifcs_2020_tutorial/ > Though, I have to honestly admit, I am not proud of it. There is too much > that > I couldn't fit what should be in there, in in the 75' we were given. And > there is > quite a few things that I think I made too confusing. Nevertheless I hope > it can > be of use for some. Please let me know what you think, especially if you > have ideas > how I could improve the tutorial for the next time I'm giving it. > > > Attila Kinali > > PS: As this years IFCS is fully virtual, the registration is still open > and the > rates are IMHO quite reasonable: https://ifcs-isaf2020.org/registration > If it's still too much, you can pretend you are a student. Nobody is > checking > this anyways. > > -- > Science is made up of so many things that appear obvious > after they are explained. -- Pardot Kynes > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com and follow the instructions there.
