Hi Tom -
I wonder if WWVH is also sending in the new format for you guys on the west coast, although you guys are closer to WWVB than I am, and the La Crosse just works great. Regards - Mike Mike B. Feher, N4FS 89 Arnold Blvd. Howell NJ 07731 848-245-9115 -----Original Message----- From: time-nuts <time-nuts-boun...@lists.febo.com> On Behalf Of Tom Van Baak Sent: Sunday, September 20, 2020 4:16 AM To: Discussion of precise time and frequency measurement <time-nuts@lists.febo.com> Subject: [time-nuts] More ES100 / WWVB BPSK chips There were couple WWVB threads recently. One of the questions was if the La Crosse UltrAtomic 404-1235UA-SS wall clock is still the only WWVB clock that uses the new BPSK format. I learned that 3 different companies made prototypes but only La Crosse went to market. So at this point the 1235UA is the only commercial clock using the new eWWVB format. Everyone who has one reports superb reception quality, far better than traditional WWVB clocks. Another question was where to get the bare Everset ES100 chip or dev boards. The original Universal Solder PCB with ES100 has been out of stock a long time. It's the one seen at <http://www.leapsecond.com/pages/es100/pins.htm> http://www.leapsecond.com/pages/es100/pins.htm The good news is that Universal Solder just announced a newly designed board: <https://www.universal-solder.ca/everset-es100> https://www.universal-solder.ca/everset-es100 Your choice of bare 12 x 16 mm board or a full Arduino-based dev kit: <https://www.universal-solder.ca/product/everset-es100-mod-wwvb-bpsk-phase-m odulation-receiver-module/> https://www.universal-solder.ca/product/everset-es100-mod-wwvb-bpsk-phase-mo dulation-receiver-module/ <https://www.universal-solder.ca/product/canaduino-application-development-k it-with-everset-es100-mod-wwvb-bpsk-atomic-clock-receiver-module/> https://www.universal-solder.ca/product/canaduino-application-development-ki t-with-everset-es100-mod-wwvb-bpsk-atomic-clock-receiver-module/ /tvb _______________________________________________ time-nuts mailing list -- <mailto:time-nuts@lists.febo.com> time-nuts@lists.febo.com To unsubscribe, go to <http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com> http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@lists.febo.com To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com and follow the instructions there.
