Sent from my iPhone
> On 10 Mar 2021, at 15:54, Dana
>
> I have convinced myself that the PPS output from my Tbolt is derived from
> the produced
> 10 MHz output, because if I trigger an o'scope from the PPS output, the 10
> MHz sinewave
> shows very little time jitter, perhaps 1 or 2 nsec. So, I'm pretty happy
> with the T'bolt, with
> two (minor) exceptions:
>
>> Its RF sensitivity seems rather poor compared to that of "modern"
> receivers (my unit
> was apparently made in the early 2000s).
>
>> In tboltmon, the signal "strength" indications are displayed in units
> called 'AMU',
> for which I've been unable to find a definition.
>
> Dana
>>
Dana,
The Tbolt is different from most GPSDOs in that the 10MHz clocks the whole
receiver. So there is no sawtooth error to correct for. Read the manual.
It is less sensitive, as was receivers from that manufacturer and age. Look in
the manual what gain is expected at the antenna port.
AMU - “a mostly meaningless unit” is how I was described it from an industry
insider. Note that you can change the unit to SNR if you want. Then SNR is also
not always comparable between manufacturers and models.
Kind regards,
Björn
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
