Its the Stock Linear AC Supply built into the MRT chassis. I dod replace the filter cap, it was pretty bad. I am implementing a DC battery system for the workbench, don't trust UPSs much but not there yet.
On Sun, 2021-06-06 at 13:05 -0400, Bob kb8tq wrote: > Hi > > Do you have a switching power supply driving the Efratom through the > DC > input? Sounds a lot like a switcher with an output cap / output > filter issue. > > Bob > > > On Jun 6, 2021, at 12:18 PM, Shawn <[email protected]> wrote: > > > > Hi Guys, > > > > The question I was going to ask about. > > > > It's getting warm around here and i had switched my RF workbench > > off > > the 5065 to an Efratom MRT clock, its setup for high temp > > operation. > > > > Well started having some wierd iisues and found that every signal > > generator had a 50KHz signal riding their output, swapping back to > > the > > 5065 the problem goes away. > > > > Ideas? Anyone had this kind of thing happen? > > > > > > Shawn > > _______________________________________________ > > time-nuts mailing list -- [email protected] -- To > > unsubscribe send an email to [email protected] > > To unsubscribe, go to and follow the instructions there. > _______________________________________________ > time-nuts mailing list -- [email protected] -- To unsubscribe > send an email to [email protected] > To unsubscribe, go to and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] -- To unsubscribe send an email to [email protected] To unsubscribe, go to and follow the instructions there.
