On the Raspberry Pi TimeHat is there output to the HDMI connector, or is
it configured to just use a serial console?
I'm using the preconfigured SDHC card, so the software should be fine.
If I swap out the SDHC card with a different one the systems boots fine,
so the hardware works.
With the card with the software there is never any output to the HDMI
connector.
Based on the LED on the GPS module it's locking up on the GPS signals
just fine. After the initial lockup, it locks up again in only a few
seconds after a power cycle.
Robert
_______________________________________________
time-nuts mailing list -- [email protected] -- To unsubscribe send an
email to [email protected]
To unsubscribe, go to and follow the instructions there.
