My 132 Power Module failed. Not made by HP. removed the white silicone one Diode was not soldered in sometimes touched, solder it in no more problems. Bert Kehren
In a message dated 12/8/2021 7:02:06 PM Eastern Standard Time, [email protected] writes: Hi The PSU in the 131 is a known weak point. Usually when they die, they take a lot of parts out in the process. The good news is that the PSU in the 53181 is the same as the 131 PSU. Since 181’s tend to sell for “not much” they are a fine parts donor …. Bob > On Dec 8, 2021, at 5:53 PM, Marek Doršic <[email protected]> wrote: > > Hello, > > while taking a measurement my HP53131a counter sparked and became quiet. >After tear down I found both 3A/240V fuses in the PSU burnt. Before pluging a >new set of fuses, is there a knowledge of a common problem that couses a >shortcircuit at the HV side? > > The counter has also a spilage at the bottom side of the mainboard, but as it > is same as in Gerry Sweeney's youtube video (HP 53131A Teardown and Spillage > Clean-Up <https://www.youtube.com/watch?v=czCLXrUPX0o>) and his counter still > works I assume it is not related. Is it a good practice to get it cleaned? > > .marek > _______________________________________________ > time-nuts mailing list -- [email protected] -- To unsubscribe send an > email to [email protected] > To unsubscribe, go to and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] -- To unsubscribe send an email to [email protected] To unsubscribe, go to and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] -- To unsubscribe send an email to [email protected] To unsubscribe, go to and follow the instructions there.
