On 2/5/22 7:00 PM, Martin Flynn wrote:
Since my homemade version did not turn out as well as I had hoped, I
was planning to have my local fab shop laser cut a rack panel for our
"new" LUCENT-SYMMETRICOM Z3810AS (KS24361)
You might also check out frontpanelexpress.com - they do nice engraved
and punched panels, remarkably inexpensively. (and basically flat plates
of any kind - I've used them for breadboards and prototypes where you
want to fasten down a bunch of minicircuits type parts).
Before break out the ruler, anyone have a dimensioned drawing of the
mounting and panel holes?
Martin A Flynn / W2RWJ
Computer Deconstruction Laboratory
2201 Marconi Road
Wall Township, NJ 07719
Tel: +01 732-456-5001
Email: martin.fl...@compdecon.org
Online: www.compdecon.org
Facebook: https://www.facebook.com/compdecon/
_______________________________________________
time-nuts mailing list -- time-nuts@lists.febo.com -- To unsubscribe
send an email to time-nuts-le...@lists.febo.com
To unsubscribe, go to and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@lists.febo.com -- To unsubscribe send an
email to time-nuts-le...@lists.febo.com
To unsubscribe, go to and follow the instructions there.