All:
I'm trying to get Lady Heather 5.00 to work with my Z3805A. I know the
Z3085A is working and talking (via direct SCPI commands over RS-232, see
below) AND Lady Heather will launch and appear to do an initial connection.
But then, Lady Heather just beeps every few seconds, and is completely
hung, necessitating killing the app. This on Windows 7.
Any ideas on what I'm doing wrong?
*E-113> SYST:STATUS?------------------------------- Receiver Status
-------------------------------SYNCHRONIZATION ............................
[ Outputs Valid/Reduced Accuracy ]SmartClock Mode
___________________________ Reference Outputs _______________>> Locked to
GPS: stabilizing frequency TFOM 4 FFOM 1
Recovery 1PPS TI -285.9 ns relative to
GPS Holdover HOLD THR 1.000 us
Power-up Holdover Uncertainty
____________ Predict 432.0
us/initial 24 hrsACQUISITION ............................................ [
GPS 1PPS CLK Valid ]Satellite Status __________________________ Time
____________________________Tracking: 3 Not Tracking: 5
GPS 07:01:42 15 Jul 2002PRN El Az SS PRN El Az
1PPS CLK Synchronized to GPS Time 10 56 254 85 *16 Acq .
ANT DLY 0 ns 15 33 55 29 *18 Acq . Position
________________________ 27 33 313 35 *23 Acq . MODE
Survey: 6.2% complete 26 14 234
Suspended: track <4 sats 29 19 150
AVG LAT N XX:XX:41.654
AVG LON W XXX:XX:38.424ELEV MASK 10 deg *attempting to track AVG
HGT +195.06 m (MSL)HEALTH MONITOR
......................................................... [ OK ]Self Test:
OK Int Pwr: OK Oven Pwr: OK OCXO: OK EFC: OK GPS Rcv: OKE-113>*
--Andrew
--------------------------------
Andrew E. Kalman, Ph.D.
_______________________________________________
time-nuts mailing list -- [email protected] -- To unsubscribe send an
email to [email protected]
To unsubscribe, go to and follow the instructions there.
